Troubleshooting - BabyCargo PLUSH + PLAY Manual De Instrucciones

17
• When not actively changing diapers, stow the Changing Table in two
easy steps.
1. Release ONLY the Clips on the short ends of the Changing Table by
lifting upward. Make sure the two HINGED Clips are still securely
seated on the Playard.
2. Pivot the Changing Table upward, gently flipping it over the
end-rail of the Playard. DO NOT STORE THE CHANGING TABLE
Click
INSIDE THE PLAYARD.

TROUBLESHOOTING

Issue: Changing Table sags when baby is placed on it
Common Cause: Table Clips are most likely not secured properly.
Solution:
• Check both rigid Clips, and both hinged Clips, for improper or
incomplete seating.
• Push downward on any unseated Clip until you hear a "click" sound
that indicates Clip is seated and secured to Playard rails.
NOTE: YOU MAY NEED TO PUSH HARDER THAN EXPECTED TO
SECURE CLIPS TO RAILS. Escalate your strength slowly until the
Clips seat into place.
Click
Click
x2
Click
x2