Connecting Speakers - Lenco DVD-517H Manual De Instrucciones

CONNECTING
SPEAKERS
This well-designed DVD receiver provides
optimum sound quality when the speakers used
are within the range of their rated impedance.
Important
The minimum impedance of the five speaker
terminals is 4 ohm; for the subwoofer, it is
8 ohm.
If you want to use only one speaker or listen
to monophonic music, do not parallel connect
individual speakers to the left and right
channel terminals. See the figure on the left
below.
100-240V
50~60Hz
Subwoofer speaker
Surround speaker
SR SL FR FL
4 4 4 4
SPEAKER OUTPUT
Main speaker
Connecting Speaker Cables
1.Peel off approximately
insulation
2.Tighten the wire end (#2 below)
3.Open cable terminal by pressing back on
tab
4.Insert wire end into terminal
5.Release tab; make sure wire is in terminal
securely
Note: To prevent damage to the circuit, care
should be taken to prevent short circuiting from
occurring at the positive and negative poles of
the speaker cord.
1
3
Surround speaker
Center speaker
AUX
AUDIO VIDEO OUTPUT
VIDEO IN
Y
SW
CEN CEN SW SW
4 8
AUX IN LINE OUT COAXIAL Pr/Cr Pb/Cb S-VIDEO
Main speaker
13
" of cable
1/ 2
2
5
4
VIDEO
AM ANTENNA
SCART IN/OUT
FM