Battery Backup Assembly Instructions; Powerreclinexr + Operating Instructions - La-Z-Boy PowerRecline XR PLUS Instrucciones De Operación

Battery Backup ssembly Instructions
Replace the power transformer batteries every six months and
NOTICE:
after each power failure use. Under normal conditions, the battery
backup will operate the chair two times, but this performance
cannot be guaranteed.
The battery backup is located in the power transformer and uses two 9-volt alkaline
batteries (not included).
1. Unplug the 120 volt power cord from the electrical outlet, and disconnect the power
transformer connector from the power supply connector.
2. The battery compartment is located in the bottom of the power transformer. Slide the battery
cover over to access the battery compartment.
3. Snap the connection caps on the battery terminals. Place the batteries in the power transformer.
4. Slide the battery cover over the batteries.
5. Proceed to the Operating Instructions.
Power (2) 9-Volt
Transformer Alkaline Batteries
PowerReclineXR
Input: 100V-240V AC 50/60Hz 86VA
Output: 29V DC 2.5A
8
Battery
Cover
Transformer Specifications:
+
®
PowerReclineXR
Operating Instructions
– To reduce the risk of electric shock, serious
DANGER
injury or death:
• Plug directly into a wall outlet. Do not use an extension cord, adapter or surge protector.
WARNING
– To reduce the risk of serious injury:
• Sit down in the unit slowly. To avoid tip over, do not throw your weight against the back
of the unit. Move the unit into or out of the reclining position slowly, making sure that
no children or pets are in close proximity.
• The PowerReclineXR + units are intended for a single occupant not exceeding 300 pounds
per seat. Do not operate an individual seat with more than one occupant in or on any
part of the individual seat.
• To safely exit the unit and prevent a tripping hazard, bring the back upright
and close the legrest.
• The operating cycle of PowerReclineXR
Plug the power cord directly into a wall outlet. Make sure there is enough slack in the cord running
from the chair to the outlet to allow for rocking and reclining. Never stretch or strain a cord.
The PowerReclineXR ® + offers three reclining options along with several adjustment
positions for the headrest and lumbar for the ultimate in customized comfort:
• Only recline the back. When the back is reclined, the chair can be rocked.
• Only extend the legrest. When the legrest is extended, the chair body tilts backward.
• Operate both the back recline and legrest extension simultaneously.
• Position the headrest forward when reclined, stopping in any one of the various angles of support.
• Increase the intensity of the lumbar support stopping in any one of the various levels
for optimal lower lumbar support.
To recline, press and hold down one of the three reclining option buttons on the right side of the
hand wand. Release the button when you have reached a comfortable position.
To return to the upright position, press and hold down one of the three return buttons on the left
side of the hand wand. Release the button when you have reached a comfortable position, or
when the back is fully upright and the legrest is fully closed.
To rotate the headrest forward, press and hold down the button on the right. To return the
headrest to the upright position, press and hold down the button on the left. Release the button
when you have reached a comfortable position, or when the headrest is fully retracted.
To increase lumbar intensity, press and hold down the button on the right. To decrease the
lumbar intensity, press and hold down the button on the left. Release the button when you have
reached a comfortable level, or when the lumbar is fully retracted.
The function of each hand wand button is explained in greater detail on the following page.
We recommend that you unplug the power transformer if you will be away from your residence
for an extended period of time.
+
®
® + units is 1 minute on and 9 minutes off.
9