Kohler K-647 Guia De Instalacion página 3

Screws
1. Install the Faucet
Slide the O-ring up to the base of the spout, then fit the faucet
through the drilled hole.
Partially thread two screws into the threaded ring until they
protrude slightly from the backside of the threaded ring.
IMPORTANT! Due to the asymmetrical design of the faucet, the
spout must be positioned with the Kohler logo facing away from the
user's normal operating position.
Properly position the spout with the Kohler logo facing away
from the user's normal operating position.
Rotate the spray wand to the intended position or to the user's
preference.
Slide the metal washer onto the shank from the underside of the
sink.
Thread the threaded ring up the shank until it is about 1/4" (6
mm) away from the underside of the sink. Ensure the screw holes
face the front and back of the faucet.
Tighten the screws.
IMPORTANT! The intended position of the spray wand is to face
the buttons away from the user's normal operating position. This
position is adjustable to provide the user with additional flexibility
to suit their personal preferences.
Kohler Co.
Spout
Shank
Spray Wand
O-Ring
Metal Washer
Threaded Ring
3 1048033-2-B