Kohler Bakersfield K-5834 Serie Instrucciones De Instalación

BEFORE YOU BEGIN
HOW TO USE THESE INSTRUCTIONS
Please read these instructions carefully to familiarize yourself with
the required tools, materials, and installation sequences. Follow the
sections that pertain to your particular installation. This will help you
avoid costly mistakes. In addition to proper installation, read all
operating and safety instructions.
NOTES
Observe all local plumbing and building codes.
Prior to installation, unpack the new sink and carefully
inspect it for damage. Return the sink to its protective carton
until you are ready to install it.
Inspect the waste and supply tubing; replace if necessary.
CAUTION: Risk of personal injury or product damage.
Cast iron sinks are very heavy. Get help lifting the sink into
place.
It is very important that the proper materials are used with
your sink. Proper selection of tile is critical for a good
installation. 3/8" tile is recommended. Because of the
variance in tile thickness, your carpenter, tiler, and plumber
must be aware of the exact type of tile you choose. After
selecting the tile, a sample of the tile should be provided to
each contractor involved in the project. It is very important
that the tiler, plumber, and carpenter maintain good
communication and discuss the requirements of the project
with each other. Failure to follow these precautions
may result in poor installation.
TOOLS AND MATERIALS REQUIRED
Sealant
Safety glasses
Pencil
Tape measure
Putty knife
Plumbers putty
C
1007255-2-
ENAMELED CAST IRON SINKS
All information in these instructions is based upon the latest product
information available at the time of publication. Kohler Co. reserves
the right to make changes in product characteristics, packaging, or
availability at any time without notice.
Due to the variety of installations possible with these sinks,
procedures other than those described in these instructions
may be required. Remember, because of the variety of tiles
available, careful measurements must be taken prior to
installation.
For a replacement installation, make sure the existing
cutout is the same size or smaller than the cutout for the
new sink.
Please leave these instructions with the consumer; they
contain important care, cleaning, and warranty information.
This fixture is not intended for undercounter installation.
Kohler Company supplies an entire product line specifically
designed for undercounter applications.
Keyhole saw or saber saw
Drill (1/2" dia. drill bit or larger)
Adjustable wrench
Pipe wrench
Tubing cutter
Español, Página 5
Français, Page 9
TILE-IN
2002 Kohler Co.