Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
EN
28. Box spanner
29. Allen key
30. Dust bag
31. Fuse box
Check the machine, loose parts and accessories
for any transport damage.
2. Safety
Symbols and meanings
The following symbols are used in these
instructions for use and on the machine:
Class II machine – Double insulation –
You don't need any earthed plug.
Denotes risk of personal injury, loss of life
or damage to the tool in case of non-
observance of the instructions in this
manual.
Indicates electrical shock hazard.
Immediately unplug the plug from the
mains electricity in the case that the cord
gets damaged and during maintenance
Keep bystanders away
Wear ear and eye protection
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Specific safety rules for table saws / mitre
saws
•
The user of the machine must be instructed in
the use, adjustment and operation of the
machine,
•
Make sure of a well-lit and clean and tidy
6
working area.
•
Never use saw blades that are bent, distorted
or in any other way damaged.
•
Never use saw blades of HSS steel.
•
Never use saw blades that do not meet the
specifications stated in these instructions for
use.
•
Never use adapters to mount saw blades with
to large an axle hole.
•
Never saw any material other than wood,
woody material, aluminium and plastics.
•
Never remove the protective hood. Make sure
that the saw blade is correctly protected by the
protective hood.
•
Check that all movable protective parts do not
stick.
•
Never saw work pieces in which there are
nails or other metal objects.
•
Never switch the machine on when the piece
of work is touching the saw blade.
•
Do not start sawing until the machine is
running at full revolutions.
•
Make sure that the piece of work is clamped
down. Never try to saw pieces of work that are
too small.
•
Never try to slow down the saw blade by
applying counter pressure to the side of the
blade.
•
Never leave the machine unattended before
you have switched it off and the saw blade has
stopped rotating.
•
Never try to saw round pieces of work with the
bench circular saw.
•
Never remove the riving knife from the table
saw. The distance between the saw blade and
the riving knife must not be more than 5 mm
maximum.
•
Make sure that dust vacuuming works
properly while working, in connection with the
danger to health caused by breathing in the
dust being produced.
•
With the table saw always use a wooden stick
to move the work piece along the saw blade.
•
When using the mitre saw, always make sure
that the saw blade is fully protected by the
protective hood.
•
When using the table saw, always make sure
that the upper bench surface is fixed properly.
•
Take the plug out of the socket when you are
carrying out maintenance of the machine. The
same goes for assembly or setting up.
•
Do not use the machine before you have
assembled and installed it completely as
described in these instructions for use.
Ferm
Publicidad
Tabla de contenido
