Worx WG540 Manual De Instrucciones De Operación Y Mantenimiento página 11

Sopladora/barredora de 18v con batería de iones de litio
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WA3840
WA3838
5. tO REmOVE OR iNStALL BAttERy
PACk(See D)
Depress the battery release button (9) to
release battery pack from your tool. After
recharging, insert the battery pack into tool's
battery port. A simple push and slight pressure
will be sufficient.
6. StARtiNG/StOPPiNG(See E)
Starting
Move the On/Off switch (2) to the "I" On
position.
Stopping
Move the On/Off switch (2) to the "O" Off
position.
wARNiNG! The tool runs for a few
seconds after it has been switched off.
Let the motor come to a complete standstill
before setting the tool down.
7. uSiNG tHE BLOwER(See F)
The blower is intended for residential use only.
Use the blower outdoors to move debris from
hard surfaces. This blower is not designed to
clear leaves from large grassy areas, or move
wet, heavy debris.
uSER tiPS
- Hold the blow tube approx 7" above the
ground when operating the tool
Use a sweeping motion from side to side.
Advance slowly keeping the accumulated
debris/leaves in front of you.
18V Cordless Li-ion Blower/Sweeper
Red Flashing
Defective battery, after pre-charge 30 minutes
Green Off
with trickle current, the total battery voltage is still
less than 10.0V (When charging 18V battery pack).
Red ON
Green Off
Charging
Green ON
Red Off
Power On and Fully Charged
Green Flashing
The temperature of battery pack is less than
Red Off
32°F(0°C) or more than 113°F(45°C)
- After blowing the debris/leaves into a pile, it
is easy to dispose of the pile.
- Do not blow hard objects such as nails, bolts,
or rocks.
- Do not operate the blower near bystanders
or pets.
- Use extra care when cleaning debris from
stairs or other tight areas.
- Wear safety goggles or other suitable eye
protection, long pants, and shoes.
STORAGe
children and animals.
1. ASSEmBLy tHE wALL mOuNt
BRACkEt
Before you attach the wall-mount bracket
to the wall, make sure to check the charger
cable length to the wall socket. Attach the
wall-mount bracket to the wall with the screws
provided.
Tighten all the screws securely. Carefully check
the bracket after mounting to make sure that
no movement can occur during use. (Fig. G1).
to the wall. Failure to do so could result in an
CAutiON!
wARNiNG! Store the blower indoors,
in a cool dry location, out of reach of
wARNiNG! Always make sure your
wall-mount bracket is securely mounted
11
11
en

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Wg540.5Wg540.9

Tabla de contenido