Cleaning The Tool - Worx WG540 Manual De Instrucciones De Operación Y Mantenimiento

accident, resulting in possible serious personal
injury.
2. CHARGER AND BRACkEt
mOuNtiNG(wG540)
To attach the charger onto the wall-mount
bracket (9-b), insert the charger into the slots in
the bracket. (See G2)
To remove the charger from the bracket, press
the release button and push the charger out of
the slots. (See G3). Be careful not to trap your
finger.
3. wALL-mOuNt CHARGiNG(wG540)
The charger can be attached in the wall-mount
brackets(9-b). The battery pack can be charged
inside the wall-mount bracket. (See G4)
4. StORiNG yOuR BLOwER
The blower can be stored into the wall mount
bracket (9-a) as illustrated (See G5).
Store in a dry place where your blower can be
protected from damage.

CLeAnInG THe TOOL

Clean the tool regularly.
12 12
wARNiNG! Keep your product dry.
Under no circumstances spray with
water.
- To clean the tool, use only mild soap and a
damp cloth.
wARNiNG! Do not use any type of
detergent, cleaner or solvent which may
contain chemicals that could seriously damage
the plastic.
- Self lubricating bearings are used in your
product, therefore lubrication is not required.
18V Cordless Li-ion Blower/Sweeper en