Cub Cadet RZT-S Manual Del Operador página 22

Cleaning the Tractor
Any fuel or oil spilled on the machine should be wiped off
promptly. Do NOT allow debris to accumulate around the cooling
fins of the engine, the transmission's cooling fan or on any other
part of the machine, especially the belts and pulleys.
Smart Jet™
Your tractor's deck is equipped with a water port on its surface as
part of its deck wash system.
Use the Smart Jet™ to rinse grass clippings from the deck's
underside and prevent the buildup of corrosive chemicals.
Complete the following steps AFTER EACH MOWING:
1. Drive the tractor to a level, clear spot on your lawn, near
enough for your garden hose to reach.
CAUTION:
chute is directed AWAY from your house, garage,
parked cars, etc.
1. Disengage the PTO (Blade Engage), set the parking brake
and stop the engine.
2. Thread the hose coupler (packaged with your tractor's
Operator's Manual) onto the end of your garden hose.
3. Attach the hose coupler to the water port on the left of
your deck surface. See Fig. 6-2.
4. Turn the water on.
5. While sitting in the operator's position on the tractor, start
the engine and place the throttle lever in the FAST
position.
6. Engage the PTO.
7. Remain in the operator's position with the cutting deck
engaged for a minimum of two minutes, allowing the
underside of the cutting deck to thoroughly rinse.
8. Disengage the PTO.
9. Turn the ignition key to the STOP
tractor's engine off.
22
S 6— M
ection aintenance
Make certain the tractor's discharge
Nozzle Adapter
Adapter Lock Collar
Deck Wash Nozzle
Figure 6-2
position to turn the
& a
djuStMentS
10. Turn the water off and detach the hose coupler from the
water port on your deck's surface.
11. After cleaning your deck with the Smart Jet™ system, return
to the operator's position and engage the PTO. Keep the
cutting deck running for a minimum of two minutes, allowing
the underside of the cutting deck to thoroughly dry.
Lubrication
WARNING!
Before lubricating, repairing, or
inspecting, always disengage PTO, set parking
brake, stop engine and remove key to prevent
unintended starting.
Front Wheels
Each of the front wheel spindles and rims is equipped with a grease
fitting. See Fig. 6-3. Lubricate with a No. 2 multi-purpose grease
applied with a grease gun after every 25 hours of tractor operation.
Grease
Fittings
Figure 6-3
Pivot Points & Linkage
Lubricate all the pivot points on the drive system, parking brake
and lift linkage at least once a season with light oil.
Tires
WARNING!
Never exceed the maximum inflation
pressure shown on the sidewall of the tire.
Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate. Uneven tire
pressure could cause the cutting deck to mow unevenly.