Cub Cadet RZT-S Manual Del Operador página 28

3. Remove the two idler pulleys by removing the hex screws
and flange lock nuts that secure them to the deck and the
idler arm. See Fig. 7-8. Do not lose any of the hardware
when removing the hex screw and flange lock nut.
Pulley Cap
Washer
Belt Guard
Flange Lock Nut
NOTE: Take note of the position of the belt guards to
ensure they are properly re-installed.
4. Remove the belt from the spindle pulleys.
5. Install the new belt around the spindle pulleys as shown
and reinstall the belt covers. See Fig. 7-7.
6. Place the belt around the idler pulleys removed in step 3
with the "V" side facing in. Once in place, reinstall all the
hardware and tighten the flange lock nut to secure the
assembly. See Fig. 7-8.
7. Route the belt as shown in Figure 7-7 and then reinstall the
deck.
28 S 7— S
ection ervice
Hex Screw
Flange Lock Nut
Pulley Cap
Idler Pulleys
Washer
Belt Guard
Idler Arm
Hex Screw
Figure 7-8
46" Deck
1. Remove the deck from beneath the tractor, (refer to Deck
Removal on page 24).
2. Remove the hex washer screws securing the belt covers to
the deck. See Fig. 7-9.
Hex Washer
Belt Cover
Screws
Spindle Pulley
Idler Pulley
Idler Arm
PTO Pulley
Figure 7-9
3. Remove the two idler pulleys by removing the hex screws
and flange lock nuts that secure them to the deck and the
idler arm. See Fig. 7-10. Do not lose any of the hardware
when removing the hex screw and flange lock nut.
Flange Lock Nut
Pulley Cap
Idler Pulley
Washer
Belt Guard
Idler Arm
Hex Screw
Flat Washer
Hex Screw
Figure 7-10
NOTE: Take note of the position of the belt guard to ensure
they are properly re-installed.
4. Remove the belt from the spindle pulleys.
5. Install the new belt around the spindle pulleys as shown
and reinstall the belt covers. See Fig. 7-9.
Spindle Pulley
Belt Guard
Idler Pulley
Flange Lock Nut
Pulley Cap
Idler Pulley
Spacer
Shoulder Spacer