Sony KDL-V40XBR1 Guia De Instalacion

Installing the Wall-Mount Bracket
English
To Customers
For product protection and safety reasons, Sony strongly recommends that wall-
mounting of your TV be performed by a reliable licensed contractor. Do not attempt
to install it yourself.
Your KDL-V40XBR1 can be wall-mounted using the SU-PW2 Wall-Mount Bracket
(sold separately). Please provide your contractor with this installation supplement as
well as the Instructions (supplied with SU-PW2 Wall-Mount Bracket). Read these
documents carefully for safety and proper installation.
To Sony Dealers and Contractors
Provide full attention to safety during the installation, periodic maintenance and
examination of this product.
Installation du support de fixation mural
Français
À l'attention des clients
Par souci de protection du produit et pour des raisons de sécurité, Sony recommande
vivement que l'installation du support de fixation mural de votre téléviseur soit
confiée à un installateur qualifié agréé. N'essayez surtout pas de procéder vous-même
à l'installation.
Le KDL-V40XBR1 peut être fixé au mur à l'aide du support de fixation mural SU-
PW2 (vendu séparément). Fournissez à l'installateur ce supplément d'installation,
ainsi que le mode d'emploi (fourni avec le support de fixation mural SU-PW2). Lisez
attentivement ces documents qui concernent la sécurité et l'installation adéquate.
À l'attention des revendeurs Sony et des installateurs
Accordez une attention particulière à la sécurité lors de l'installation, de l'entretien
périodique et de la vérification de ce produit.
Instalación del soporte de montaje mural
Español
Para los clientes
Por razones de protección del producto y de seguridad, Sony recomienda que el
montaje mural del televisor sea realizado por un contratista autorizado de Sony.
No intente instalarlo usted mismo.
Puede instalarse el modelo KDL-V40XBR1 en una pared mediante el soporte de
montaje mural SU-PW2 (se vende por separado). Muestre al contratista este
suplemento para la instalación, así como el manual de instrucciones (suministradas
con el soporte de montaje mural SU-PW2). Lea atentamente estos documentos para
realizar la instalación correctamente y de manera segura.
Para distribuidores y contratistas de Sony
Ponga especial atención a la seguridad durante la instalación, mantenimiento
periódico y comprobación de este producto.
© 2005 Sony Corporation
Printed in Japan
English
Installing the TV
on a wall
The TV can be installed on a wall by attaching a Wall-
Mount Bracket (sold separately).
Verify your TV's model number and be sure to use the
bracket specified for your model only. Refer to the
Steps on this leaflet along with the Instructions
supplied with SU-PW2 Wall-Mount Bracket, to
properly carry out the installation.
Sufficient expertise is required for installing this
product. Be sure to subcontract the installation to
Sony dealers or licensed contractors and pay
special attention to safety during the installation.
Sony is not liable for any damages or injury
caused by mishandling or improper installation.
Your Statutory Rights (if any) are not affected.
Step 1: Check the parts required
for the installation
Open the Wall-Mount Bracket package and check the
contents for all required parts along with the
Instructions.
KDL-V40XBR1
2-599-866-11(1)
Step 2: Decide on the installation
location
Decide where you want to install your TV. Turn to the
back cover of this leaflet for the display installation
dimensions and determine the location.
If you intend to route the cables in the wall, also
determine the position of the cable hole and bore a
hole in the wall.
Hole for cable routing
(One of two)
Refer to the Instructions for the SU-PW2.
Step 3: Install the Plate Unit on
the wall
Change the position of the Mounting Hook Unit
supported shafts.
Refer to the Instructions for the SU-PW2.
Prepare for the installation of the
TV
Before removing the Table-Top Stand, disconnect all
the cables from the TV.
Refer to the Instructions for the SU-PW2.
Place the TV, with its screen facing
1
down, on a stable, cloth-covered
work surface, at least 20 cm (8 in)
off the floor.
English Installation dimensions table
Français Tableau des dimensions pour l'installation
Español Tabla de las dimensiones de instalación
A
Screen centre line/
Ligne centrale de l'écran/
Línea del centro de la
pantalla
Display Model/ Display Dimensions/ Unit: mm (inches)/
Dimensions de l'écran/ Unité : mm (pouces)/
Modèle d'écran/
Dimensiones de la pantalla Unidad: mm (pulgadas) Longitud de cada ángulo de montaje
Modelo de
A B C D
pantalla
1014.4 683.3 121.3 273
KDL-V40XBR1
(40) (27) (4 7/8) (10 3/4)
* The wall must be strong enough to support at least four times the weight of the display that you are installing./
* Le mur doit être suffisamment solide pour supporter au moins quatre fois le poids de l'écran que vous installez./
* La pared debe ser suficientemente resistente para soportar como mínimo cuatro veces el peso de la pantalla que está instalando.
2 Remove the screws that hold the
TV to the Table-Top Stand and
detach the Table-Top Stand from
the TV.
Note
First remove the cable holder if it is attached to
the TV. For details on the cable holder, refer to
the instruction manual of the TV.
3 Attach the supplied four hooks
with the supplied four screws
(+PSW5 × L16).
Note
When using an electric screwdriver, set the
torque setting to approximately 2 N·m.
Screw into the recessed screw holes.
Step 4: Install the TV
Refer to the Instructions for the SU-PW2.
F
C
B
B
D
E
Length for each mounting angle/ Unit: mm (inches)/
Longueur de chaque angle de montage/ Unité : mm (pouces)/
Unidad: mm (pulgadas)
Mounting angle ( α °)/
Angle de montage ( α °)/
F G
E
Ángulo de montaje( α °)
0° 164 (6 1/2) 285 (11 1/4) 104 (4 1/8)
5° 211 (8 3/8) 274 (10 7/8) 112 (4 1/2)
104
10° 257 (10 1/8) 259 (10 1/4) 119 (4 3/4)
(4 1/8)
15° 300 (11 7/8) 241 (9 1/2) 125 (5)
20° 342 (13 1/2) 218 (8 5/8) 129 (5 1/8)
G
H
Weight/
Poids/
Peso
(×4)*
H
28.1 [28,1] kg
(62 lb)
(112.4 kg
(247 lb 13 oz))