Setting Dip Switches - LUCCI FUTURA ECO Serie Manual Del Usuario

HOW TO USE THE FAN/LIGHT WITH REMOTE CONTROL

SETTING DIP SWITCHES

When two or more fans are located near each other, you may desire to have the receiver/transmitter for each
fan set to a different code, so that the operation of one fan does not affect the operation of the other fans.
The DIP switches for the receiver are located on the flat surface of the receiver. The DIP switches for the
transmitter are in the battery compartment. Fig. 11.
NOTE: Ensure that the power to the supply wires has been turned off before setting the code.
NOTE: Before you change the DIP switch settings, make sure the battery is not connected to the transmitter.
Figure 11 Figure 12
Change the position of the DIP switches in the remote transmitter and the receiver. Make sure that the DIP
switches match in the remote receiver and transmitter. If they don't match, the transmitter will not function. Fig.
12
6