Monogram WD35X20417 Instrucciones De Instalación página 13

CONNECT DRAIN LINE
STEP 17
The molded end of the drain hose will fit 5/8" through 1"
diameter inlet ports on the air gap, waste tee or disposer.
• Determine size of inlet port.
• Cut drain hose connector on the marked line, if required,
to fit the inlet port.
Cutting Line
1"
IMPORTANT: Do not cut corrugated
Figure Z
• If a longer drain hose is required and you did not
purchase drain hose WD24X10065, add up to 66"
length for a total of 144" (12 feet) to the factory-installed
hose. Use 5/8" or 7/8" inside diameter hose and
a coupler to connect the 2 hose ends. Secure the
connection with hose clamps.
Figure AA
NOTES:
• DRAIN CONNECTION HEIGHT IS NOT TO EXCEED
72" ABOVE BOTTOM OF DISHWASHER.
• TOTAL DRAIN HOSE LENGTH MUST NOT
EXCEED 12 FEET FOR PROPER DRAIN
OPERATION.
Dishwasher Installation
5/8"
portion of hose
CONNECT DRAIN LINE
STEP 17
(CONT.)
• Connect drain line to air gap, waste tee or disposer
using the previously determined method. Secure
hose with a screw-type clamp.
Method 1 – Air gap with waste tee or disposer
Waste Tee Installation
Method 2 – "High drain loop" with waste tee or
disposer
With this method you will need the drain hose hanger
set aside in Step 1.
Fasten drain hose to underside of countertop with the
provided hanger.
Drain Hose Hanger
18"
Min.
Waste Tee Installation
IMPORTANT – When connecting drain line to
disposer, check to be sure that drain plug has been
removed. DISHWASHER WILL NOT DRAIN IF PLUG
IS LEFT IN PLACE.
Tip: Avoid unnecessary service call charges for a
no drain complaint.
Make sure excess drain hose has been pulled through
the cabinet opening. This will prevent excess hose
in the dishwasher cavity from becoming kinked or
crushed by the dishwasher.
13
Disposer Installation
Figure AB
32"
18"
Min.
Min.
Disposer Installation
Figure AC
Remove
Drain
Plug
32"
Min.