Yakima Q-TOWERS Manual Del Usuario página 6

Assemble front Q-Clips and lock housings.
• Insert the correct clip through
the slits in clip holder.
• Insert lock housing through
holes in clip and clip holder.
Loosely attach cam covers.
DO NOT MOVE TOWERS! If you
bump the towers you'll need to go
back and reposition them (step 9).
• Open both driver's side and
passenger side front doors.
• Carefully thread adjustment post
on to tower to get the cover
loosely attached (2 turns max).
• Repeat for other side.
• Carefully push the clip in place up
against the door frame. DO NOT
mOVE THE TOWERS.
• using the adjustment post, take
slack out of the system until the
cam cover closes easily while
holding the clip to the door frame.
DO NOT FULLY TIGHTEN.
• Repeat for other side.
Check your M2 again. Correct if needed (step 10).
1033432H-6/30
• Place clip fastener
over lock housing to
secure assembly.