Yakima Q-TOWERS Manual Del Usuario página 7

a
The objective:
complete once you achieve balanced tower tension.
BALANCED TOWER TENSION REQUIREMENTS
1. Cam Cover closes with firm and equal resistance
on both sides of the vehicle.
2. gold Slider positions are equal on both sides of the
vehicle. Reference hash marks on tower body.
3. For Bladed Clips Only: gold Slider position must
also be ON OR BETWEEN HASH mARkS.
b The technique:
full turn at a time, alternating from driver's side tower to passenger's side tower. Close the
Cam Cover after each adjustment. Only one Cam Cover can be open at a time.
START
HERE
Alternate from
driver's side to
passenger's side.
1033432H-7/30
Install System
Your installation will be
Slowly tighten your towers by turning the adjustment posts clockwise one
Hold tower base. While
holding the clip in place
with your thumb, tighten
adjustment post one
turn, then...
Perform this technique on both the driver side and passenger side in
an alternating fashion until you achieve balanced tower tension.
slider
lower cam cover
with opposite thumb
until cam cover is
under tension, then...
use both thumbs to
snap the cam cover
shut.
hash
marks
gold
bladed clips
(see page 2)
bring both thumbs up
to cam cover while
pulling tower base
towards you...