Klarstein VINOVILLA SMART Manual Del Usuario página 32

EN
32
5 Remove the upper and lower door hinges (7/8) with the hex screwdriver (5) and
install the door hinges on the opposite side (see figure 3 & 4).
6 Rotate the door 180° and install the door on the right side of the wine refrigerator
(see figure 5).
7 Finally, attach the decorative nails and the drop guard on the opposite side (see
figure 6).
Handle Installation Method
1 Take out handle from cabinet, then
take out four pcs 4*35 screws from
accessory bag.
2 Pull open door seal from the side of
door, then insert screws into the 2
handle holes on side of door, then
put the screws alignment the hole of
handle , tighten the screws by Phillips
screwdriver then compress the door seal
3 If the screws holes of the handle don't
match perfectly with the holes of the
door, please use the electric drill to drill
the holes of the door a bit big (in surface
side), in order to install the handle
perfectly.