Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Installation Instructions
Step 1: Mount bracket to wall
NOTE: Install the unit so that the top of the
sprayhead is 33"-45" (838mm - 1142mm) from the
finished floor.
1. Rough-in 1/2" IPS supply piping from wall where
eye/face body wash is desired.
2. Install three suitable anchors for #8 screws
(supplied by installer) into wall.
• Use hook flange as a template to mark
anchor/screw locations.
3. Mount the bracket to the wall using three #8
screws (supplied by installer).
Step 2: Connect hose assembly
1. Connect 1/2" IPS elbow provided to 1/2" IPS
supply piping from wall (see Figure 1).
2. Connect end of hose assembly to 1/2" IPS elbow
installed in Step 2, procedure #1 (see Figure 1).
Step 3: Connect water supply
1. Mount safety sign using sign-mounting hardware
(supplied by installer).
2. Open water supply line and test for leaks and adequate water flow.
7
10
Figure 2
Bradley Corporation • 215-314 Rev. J; EN 05-536
3
4
1
2
9
1A
6
12"
(305mm)
Connect to 1/2" IPS
Supply (by installer)
Figure 1
Parts List
Item
1
1A
2
3
4
5
5
6
7
8*
9
10
* Not Shown
8"
(203mm)
Width (from front)
Part No.
Qty
Description
S27-265
1
Valve, Hose Spray
269-661
1
Handle, Valve
113-544A
1
Nipple
S05-158
1
Sprayhead Assy.
S53-063
1
Tethered Dust Cover
269-053
1
Hose, 12-Ft. (S19-600)
269-054
1
Hose, 25-Ft. (S19-610)
169-078
1
Reducing Coupling
S70-084
1
Wall Hook
204-421
1
Emergency Tag
113-006EF
1
Nipple
169-208
1
1/2" IPS Elbow
7/8/05
S19-600, S19-610
8" (203mm)
3
Publicidad
