How To Use The Water Kettle; Special Tips; Cleaning And Maintenance; Decalcification - MIA EW 3672 Manual Del Usuario

Jarra eléctrica de acero inoxidable
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
Place the unit on a stable, dry non-slip and heat resistant surface. Close the lid properly.
Connect the appliance to the current.
H
H
o
o
w
w
t
t
o
o
u
u
s
s
e
e
t
t
h
h
e
e
w
w
a
a
t
t
e
e
r
r
k
k
e
e
t
t
In order to fill in water, always lift off the kettle from the base station.
Open the lid and fill the reservoir with fresh water. The quantity of water filled in has to be
between MIN and MAX at the water level scale – don't exceed or under-run.
Close the lid carefully until locked. The automatic switch-off works only with a properly
closed lid.
Put the kettle on its base station and switch-on the appliance by pressing the ON/OFF
switch.
The kettle switches off automatically some seconds after the water has started to boil.
Manual switch-off is possible at any time.
If you want to re-boil the water, switch on the appliance again. The boiling process can be
interrupted at any time.
In order to open the lid, pull the unlocking button. In order to prevent scald injuries, pay
attention that neither hot water nor hot steam escape.
The appliance is protected by a security system, which automatically switches off the
kettle, if it is switched on by mistake without water or with not enough water (protection
against dry running).
You may switch-off manually at any time.
After each use for safety reason unplug the appliance
S
p
e
c
i
a
l
t
i
p
s
S
p
e
c
i
a
l
t
i
p
s
The kettle will automatically switch off, control lamp will switch off. To re-boil simply switch
on again. You may interrupt the boiling at any time by switching off.
The appliance is equipped with a safety system and will automatically cut off, should the
kettle be accidentally operated without or with not enough water.
C
l
e
a
n
i
n
g
a
n
d
m
a
i
n
t
e
n
a
n
C
l
e
a
n
i
n
g
a
n
d
m
a
i
n
t
e
n
a
n
Never allow the connector parts to become wet nor immerse the kettle into water. Wipe the unit
only with a damp cloth. Furring up is a common problem in hard water areas, and it is
recommended that a de-scaling fluid is used to remove the deposits.
The guarantee covers manufacturing and material faults whereas limestone removing as part of
cleaning and maintenance is not covered.
D
e
c
a
l
c
i
f
i
c
a
t
i
o
n
D
e
c
a
l
c
i
f
i
c
a
t
i
o
n
The decalcification interval depends on the hardness of the water and the frequency of use.
Decalcification should be carried out every 1 – 3 month. Please use common decalcification
agent (commercially available) and read and follow its instructions of use closely.
T
e
c
h
n
i
c
a
l
d
a
t
a
T
e
c
h
n
i
c
a
l
d
a
t
a
220-240V ~ 50Hz, 1850-2200W
This appliance is tested according to GS and corresponds to CE directives.
t
t
l
l
e
e
c
e
c
e
13

Publicidad

Tabla de contenido
loading

Tabla de contenido