Abicor Binzel Maxi Flex/HD Instructivo De Servicio página 23

MasterLiner Maxi Flex/HD; Basic Flex/HD
Type Pro- Kevlar sheath
tective
corru-
gated
pipe
Basic Flex
Basic HD
Maxi Flex
Maxi HD
Tab. 3 MasterLiner versions
1 Without auxiliary drive (depending on the process and the system setup)
2 With dynamic laying
3 Bending radius during wire inching
Type A
Arc welding and soldering applications
Machine applications, submerged arc welding applications, flame
spraying applications and arc welding and soldering applications
Medium mechanical loads
Suitable for laying in cable carrier chains *
Tab. 4 Areas of application
(*) Note the tensile strength of the MasterLiner used.
Wire feed irregularities
Wire feed irregularities due to the lowest permissible bending radii being breached, the number of bending
radii and wire feed distances exceeding 25 m.
• Please note the specifications with regard to the permissible bending angles, bending radii and maximum
• Use an additional drive in the event of wire feed distances of over 25 m.
MasterLiner HD
with QC quick connector and threaded connection
Tab. 5 MasterLiner connections
Outer Wire ø Max. wire feed
ø mm range mm speed m/min
34
0.8 – 1.2
27
30
34
1.2 – 4.0
32
CAUTION
lengths.
 3.2 Suspension/total bending angle of all bending radii on page EN-6
Basic HD G1/4
Hose ø 27 mm
Largest ø 32 mm
Maxi HD G1/4
Hose ø 34 mm
Largest ø 40 mm
Smallest Weight Tensile
permissible per g/m strength
bending N
radius mm
490 600
530 1,500
2 3
150 /300
610 600
540 1,500
Type B
Robot welding and soldering applications
Machine applications, submerged arc welding applications,
flame spraying applications
High mechanical loads
Suitable for laying in cable carrier chains *
MasterLiner Flex
with QC quick connector and threaded connection
Max. rec. Area of
wire feed application
1
distance type
A
A, B
25 m
A
A, B
Basic Flex G1/8
Hose ø 34 mm
Largest ø 34 mm
Basic Flex G1/4
Hose ø 34 mm
Largest ø 38 mm
EN - 5