Setup Of The Individual Components En; Suspension/Total Bending Angle Of All Bending Radii En - Abicor Binzel Maxi Flex/HD Instructivo De Servicio

3 Product description
MasterLiner HD
with QC quick connector and threaded connection
Tab. 5 MasterLiner connections
3.1.1 Setup of the individual components
1
6
1 Fully assembled MasterLiner
2 Connection element
Fig. 1 Setup of the individual components
3.2 Suspension/total bending angle of all bending radii
Wire feed irregularities
Wire feed irregularities due to the lowest permissible bending radii being breached, too many bending
radii and wire feed distances exceeding 25 m.
• Please note the specifications with regard to the permissible bending angles, bending radii and
• Use an additional drive in the event of wire feed distances of over 25 m.
EN - 6
2
3 Wire guide element
4 Assembled freely rotatable wire
guide element
CAUTION
maximum lengths.
 3.2 Suspension/total bending angle of all bending radii on page EN-6
MasterLiner Maxi Flex/HD; Basic Flex/HD
MasterLiner Flex
with QC quick connector and threaded connection
3 4
5 MasterLiner Maxi HD with
aramid outer jacket
Maxi Flex QC
Hose ø 34 mm
Largest ø 40 mm
Maxi Flex G1/4
Hose ø 34 mm
Largest ø 40 mm
5
6 MasterLiner Maxi Flex with PA
outer tube