Maintenance And Cleaning - Abicor Binzel Maxi Flex/HD Instructivo De Servicio

MasterLiner Maxi Flex/HD; Basic Flex/HD
7 Operation
NOTICE
• As the MasterLiner is integrated into a welding system, its operation depends on the control system.
8 Putting out of operation
NOTICE
• As the MasterLiner is integrated into a welding system, the process for putting it out of operation

9 Maintenance and cleaning

Under normal operating conditions, the MasterLiner does not require maintenance. Despite the above,
scheduled maintenance and cleaning are prerequisites for a long service life and a reliable operation.
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Disconnect all electrical connections.
Electric shock
Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation and damage.
• Replace any damaged or worn parts.
NOTICE
• Maintenance and cleaning work must only be carried out by qualified personnel (in Germany, see
• Always wear your personal protective equipment when performing maintenance and cleaning work.
• Please also consult the operating instructions for all welding components, e.g. the coolant recirculator,
Please make sure that the procedures for putting all the components integrated in the welding system
into operation are strictly observed.
depends on the control system. Please make sure that the shutdown procedures for all components
integrated in the welding system are strictly observed.
DANGER
DANGER
TRBS 1203).
wire feeder and welding torch.
EN - 15