Philips HR 4320 Manual De Instrucciones página 5

Important
• Read these instructions in conjunction
with the illustrations before using the
appliance.
• Do not immerse the appliance in water or
other liquids.
• Do not use the appliance outdoors or in
a humid environment.
• Always disconnect the appliance from
the wall socket before taking off parts
and before cleaning.
• The appliance can be cleaned with a
damp cloth, if required with some
detergent.
• When disassembling: do not touch
moving parts. Allow the Rota filter to
stop in its own time.
• Use only the original Philips filters.
• Do not obstruct the air inlet and air outlet
grilles. Do not place the appliance on a
soft surface such as a bed or couch.
• Keep the mains cord away from heated
surfaces.
• If the mains cord of this appliance is
damaged, it must only be replaced by
Philips or their service representative, as
special tools and/or parts are required.
• Save these instructions for further
reference.
• The appliance has an influence upon the
air circulation in the room. In general, it
is not advisable to use it near an open
hearth fire.
General description
A
Air inlets (3)
B
Pre-filter
C
Rota filter
D
Fixing nut for Rota filter
E
Hepa filters
type HR 4320: 2 filters
type HR 4330: 3 filters
F
Pilot light "On"
G
Air outlet
H
Speed control
O = off
= low speed
•
= normal speed
•
turbo
= high speed
I
"Filter full" indicator
J
Handle
K
Cord storage
(fig. 8)
How to use
• For quick air cleaning, set the speed selector to
the "turbo" setting.
After approximately half an hour, set the switch
to the position for normal speed.
• To maintain clean, fresh air in your room all the
time, it is best to run your machine continuously
on low or normal speed, depending on room
size and the degree to which the air tends to
contaminate.
• Clean and replace your filters regularly,
especially if the appliance is used in a smoky
environment.
How to clean or replace the filters
General advice
• Remove and clean the Pre-filter and the Rota
filter at least every two months.
• Remove and replace the Hepa filters as soon
as the colour of their undersides corresponds to
the darkest grey on the "Filter full" indicator.
• Check the filters right away if the appliance
becomes noisier. Clean and/or replace the
filters if necessary.
It may be necessary to clean the filters more
frequently. This depends on:
• How much the appliance has been used
(operation time, speed).
• The condition of the air to be filtered.
Removing the filters
- Set the speed selector to position O (fig. 9).
- Remove the mains plug from the wall socket.
- Remove the front cover (fig. 10).
- Remove the Hepa filters (fig. 11).
- Turn the Hepa filters.
- Compare the colour of their undersides with
the colours on the "Filter full" indicator (fig. 12).
- Replace the Hepa filters as soon as the colour
of their undersides corresponds to the darkest
grey on the "Filter full" indicator (fig. 13).
- Remove the Pre-filter (fig. 14).
- Remove the Rota filter (fig. 15).
To place the filters back reverse this process.
Safety lock
The front cover has a safety lock which prevents
you from opening the cover whilst the Air Cleaner
is switched on.
The safety lock also prevents you from switching
on if the front cover is removed.
5