Breitling BENTLEY SUPERSPORTS B55 Manual Del Usuario página 24

i) Synchronizing the seconds hand
If the seconds hand does not position itself exactly on 0 in
as follows:
• Pull the crown into position 2.
• Press P1 to activate synchronization of the hand (
• Turn the crown to reposition the hand on 0.
• Press the crown into neutral position 1.
11. LAP TIMER CHRONOGRAPH (
LAP TMR
The lap timer chronograph allows several times to be recorded one after the other.
When the recording stops, the next one starts automatically. A maximum of 50
times can be stored and reread when the recording is finished.
When the function is selected, the seconds hand positions itself automa-
LAP TMR
tically on 0 and becomes the chronograph hand. With each new recording, the
hand goes back to zero and positions itself directly above the second in progress.
It returns to its usual function when the lap timer chronograph function is exited.
a) Recording several laps ( )
LAP
• Select the function by turning the crown.
LAP TMR
mode, proceed
CHR ADD
).
SyNCHRO
)
42
• Start recording the 1 st lap by pressing P1 (
• Stop recording the 1 st lap by starting the 2
display then switches to the following lap time.
• Repeat for xx laps ( xx ) up to a maximum of 50 laps.
L RUN
• Stop the recording (thus the last lap) by pressing P2 (display
with the 1/100 th of a second on the upper screen and showing the time of the
last lap on the lower screen).
• Pressing P2 again displays the best time corresponding to lap xx on the lower
screen (showing xx on the upper screen alternating with the 1/100
BEST
second).
• Pressing on P2 yet once again displays the total time on the lower screen
(showing on the upper screen alternating with the 1/100
TOTAL
• Then, successive presses on P2, will display the time of the other laps on the
lower screen (indicating the lap displayed on the upper screen:
seconds, the display returns to the last lap.
• A long press on P2 will erase all the times (
If one forgets to turn the timing off, when the total time reaches 99 hours,
59 minutes and 59 seconds, timing ceases. The active lap displays
(for overflow). The preceding laps can however still be read.
)
L01 RUN
nd ( ) by pressing P1. The
L02 RUN
xx alternating
STOP
th
of a second).
xx). After 10
LAP
).
RESET
LAP
43
th of a
xx
OVF