KYMCO XCITING 400i Manual Del Usuario página 8

9) Check belt for wear; renew it if damaged or worn (refer to the
vehicle use and maintenance manual).
10) Refit the belt. Fit the Variotop assembly previously assembled.
11) Fit the original spacer bush.
12) Tighten the nut (tightening torque of 82 Nm) after greasing the
thread and the primary pulley nut seat.
IMPORTANT: comply with the indicated tightening torque since a
lower torque could make the nut come loose resulting in serious
crankshaft damage.
Note: the filter on transmission cover must be cleaned to ensure
efficient converter cooling; it is hence recommended to clean it
or replace it if necessary.
VARIOTOP "TPR" SPARE PARTS
Bushing
Block holder plate
Set of 9 g weights
Set of 10 g weights
Shim set
Driving blocks
TIPS ON HOW TO CALIBRATE
AND MAINTAIN THE "VARIOTOP"
Weights:
In order to obtain top performance from your Variotop, it is indispensable
that you shift gear at an rpm value close to maximum rpm (redline).
To decrease the shift rpm you simply need to change the centrifugal
weights with heavier ones. While installing lighter weights results in
an increase of shift rpm.
8
9932880
9927140
9933100
9924590
9926840
9927150