Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

S S t t a a r r t t H H e e r r e e - -
1
Verify Your Model
Model
280
1
14
13
12
5
11
10
9
10) BIO-Wheel
11) Spray
12) Spray Bar
6
2
13) Media Container
15
14) Filter Cartridge
7
3
15) Filter Box
4
8
*preinstalled
3
Assemble Intake
Attach Strainer to
A.
Extension Tube.
Attach Extension Tube to
B.
Mid-Level Intake Strainer.
Attach Mid-Level Intake
C.
Strainer to bottom
end of Intake Tube.
Insert Intake Tube into
D.
Flow Manifold Housing.
NOTE:
Short end of Intake Tube must
be inserted all the way down into Housing.
Adding Fish:
Before adding any fish, dechlorinate your aquarium water (with BIO-Safe™ Tap Water
Detoxifier) and allow your Emperor Power Filter to operate for 24 hours. Start with 2-3 fish per 10 gallons
of water. Add more fish gradually over a 4-6 week period.
Emperor
1
1) Two-Way Hinged Cover
2) Flow Manifold
Housing*
3)
Impeller*
4) Flow Manifold Housing
Cover*
13
5) Intake Tube
6) Mid-Level Intake Strainer
11
7) Extension Tube
5
8) Strainer
9) BIO-Wheel
*
®
2
Bearings*
Bar*
6
O-Rings*
10
3
7
4
8
Flow Manifold Housing
NOTE:
Housing, Impeller and Flow
Manifold Housing Cover
are preinstalled.
Power Filter
®
2
Models
400
14
C.
BIO-Wheel(s) should
rest securely in
BIO-Wheel Bearings.
12
15
10
9
BIO-Wheel Bearings
4
Impeller
Flow Manifold
Housing Cover
Flow Manifold
Quick Setup Guide
Install Filter Cartridge(s)
and Media Container
A.
Rinse Filter Cartridge thoroughly. Install as
shown (blue side toward back of Filter Box).
Open and fill one side of Media Container.
B.
Close and rinse thoroughly. Install as shown.
Install and Fill
A.
B.
C.
To start your system, just plug it in.
Adjust Spray Bar(s) to desired
angle for water flow.
Spray Bar
NOTE:
Drip Loop (for safety)
Questions or Missing Parts?
Call Customer Service at:
(800) 322-1266
Replace Filter Cartridge every 2 - 4
weeks. NEVER clean or replace
BIO-Wheel (unless damaged). Wheel
discoloration is normal and desirable.
If excessive buildup occurs, rinse
BIO-Wheel gently with dechlorinated
water (room temp) as needed. Refillable
Media Container is for adding other
filtration media. If preferred, an additional
Filter Cartridge can be used in place of
the Media Container.
Before adding water,
install assembled Emperor
on back of aquarium frame.
Fill Filter Box with aquarium
water until it spills into aquarium.
Replace Filter Cover.
10/07 11298

Publicidad

loading

Resumen de contenidos para Marineland EMPEROR

  • Página 1 Questions or Missing Parts? Call Customer Service at: Detoxifier) and allow your Emperor Power Filter to operate for 24 hours. Start with 2-3 fish per 10 gallons (800) 322-1266 of water. Add more fish gradually over a 4-6 week period.
  • Página 2 A. Conecte el colador al tubo de extension. A. Avant d’ ajouter de l’ eau, installer le filtre Emperor qui est assemblé , der- Cubierta de la caja colector de flujo A. Attacher la cré pine au tube de rallonge.