Descargar Imprimir esta página

Publicidad

Enlaces rápidos

IMPORTANT SAFETY INSTRUCTIONS
WARNING -
To guard against injury, observe basic safety precautions, including the following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
DANGER - TO AVOID POSSIBLE ELECTRICAL SHOCK.
Since water is employed in the use of aquarium equipment, special care should be taken to avoid possible electric shock.
For each of the following situations, do not attempt any repairs by yourself; return the appliance to an authorized service facility
for service, or discard the appliance.
1. If the appliance falls into water, DON'T reach for it! First, unplug it and then retrieve it. If
electrical components of the appliance get wet, unplug the appliance immediately.
2. Carefully examine the appliance after installation. Unplug the appliance if there is water
on parts not intended to get wet.
3. Do not operate any appliance if it has a damaged cord or plug, or if it is malfunctioning,
or if it has been dropped or damaged in any manner.
4. To avoid getting the appliance plug or receptacle wet, position the aquarium to the side
of a wall-mounted outlet in order to prevent water from dripping onto the plug or outlet.
Arrange a "drip loop" for each cord connecting an aquarium appliance to an outlet. (See
Illustration A.) The "drip loop" is the part of the cord below the level of the outlet that
prevents water from traveling along the cord and coming in contact with the outlet. (If
using an extension cord, the "drip loop" is located below the level of the connector.)
5. If the plug or outlet should get wet, do not unplug the cord. Disconnect the fuse
or circuit breaker that supplies power to the appliance. Once the power has been
disconnected, unplug the cord and examine it for the presence of water in the outlet.
6. Always unplug the appliance from an outlet when it is not in use. Also unplug it before
cleaning, and prior to disconnecting or attaching parts. Never yank the cord to pull the
plug from the outlet. Grasp the plug and pull to disconnect.
7. The filter is designed to operate while filled with water. If the filter runs "dry" over
an extended period of time, the motor should be examined to determine if its plastic
surfaces have warped or melted. If so, replace the motor.
8. Do not use an appliance for anything other than its intended use. Do not use
attachments that are not recommended or sold by the manufacturer; they may cause an unsafe condition.
9. Do not install or store the appliance where it will be exposed to the weather or to temperatures below freezing.
10. Make sure the appliance is securely installed before operating it.
11. If an extension cord is necessary, use a cord with a rating that matches or exceeds the rating of the appliance. A cord
rated for fewer amperes or watts than the appliance rating may overheat. Arrange the cord so that it will not trip anybody,
or be pulled in any way.
12. This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit in a polarized
outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified
electrician. Never use with an extension cord unless the plug can be fully inserted. Do not attempt to defeat this safety
feature.
13. To avoid injury, do not touch hot or moving parts.
14. Read and observe all notices on the appliance.
15. Supervise children closely when they are near or using the appliance.
SAVE THESE INSTRUCTIONS
LIMITED THREE YEAR WARRANTY: United Pet Group, a division of Spectrum Brands, Inc.(UPG)
warrants this product against defects in material or workmanship for three years from the date of original
purchase, subject to the conditions and exceptions stated below. Your sales receipt is your Proof-of-Date-
of-Purchase. If the product exhibits such a defect, UPG will repair or replace it, at UPG's option, without
cost for parts or labor. The product must be shipped postage paid to UPG. Proof-of-Date-of-Purchase is
required. You are responsible for proper shipping. Call Customer Service at 1-800-322-1266 for return
authorization and shipping address. This warranty does not cover damage caused by accident, misuse,
abuse or failure to follow the instructions accompanying this product. All implied warranties, including
any implied warranty of merchantability or fitness for any purpose are limited to three years from the date
of original purchase. Fish and plant loss, personal injury, property loss or damage (direct, incidental,
or consequential) resulting from the use of this product are not covered by this warranty. Because some
states/provinces do not allow the exclusion or limitation of incidental or consequential damages, or allow
limitations on how long an implied warranty lasts, the above limitations or exclusion may not apply to
you. This warranty gives you specific legal rights. You may also have other rights which vary from state/
province to state/province.
AQUARIUM
APPLIANCE
POWER
CORD
DRIP
LOOP
KEY
Parts Diagram & Identification
2
1
3
4
8
Replacement Parts List
ITEM DESCRIPTION
1
Valve Block
2
Impeller Assembly
3
Filter Media Securing Plate
4
Stack n' Flo Filter Trays
5
Intake Tube & Strainer/Outlet
Tube, Elbow & Diffuser
6
Vinyl Tubing
7
Suction Cups
8
Snapper Clamps
9
Gasket Kit
(Not Pictured)
Questions or Missing Parts: Call Customer Service at
(800) 322-1266
5
7
6
MODEL NUMBER
160
220
360
ML90773
ML90773
ML90774
PRIM160
PRIM220
ML90775
PR11526
PR11526
PR11527
PR11719
PR11719
PR11758
PR11721
PR11721
PR11760
PA11487
PA11487
PA11488
PR11723
PR11723
PR11762
PR11724
PR11724
PR11763
ML90771
ML90771
ML90772

Publicidad

loading

Resumen de contenidos para Marineland Magniflow 160

  • Página 1 Parts Diagram & Identification IMPORTANT SAFETY INSTRUCTIONS WARNING - To guard against injury, observe basic safety precautions, including the following: READ AND FOLLOW ALL SAFETY INSTRUCTIONS DANGER - TO AVOID POSSIBLE ELECTRICAL SHOCK. Since water is employed in the use of aquarium equipment, special care should be taken to avoid possible electric shock. For each of the following situations, do not attempt any repairs by yourself;...
  • Página 2 NORMAS DE SEGURIDAD IMPORTANTES IMPORTANTE: Desconecte siempre el sistema antes de hacer una inspección o de quitar una pieza. ADVERTENCIA - Para protegerse contra posibles lesiones, observe las precauciones de seguridad básicas, incluyendo las siguientes: LEA Y SIGA TODAS LAS INSTRUCCIONES DE SEGURIDAD PELIGRO - PARA EVITAR SUFRIR UNA POSIBLE DESCARGA ELÉCTRICA.

Este manual también es adecuado para:

Magniflow 220Magniflow 360