Connections To Your Tv; Rf Coaxial Connection; Component Video Connection - LG DR265-M Manual Del Usuario

Connections to Your TV

Make one of the following connections, depending
on the capabilities of your existing equipment.
Tips
Depending on your TV and other equipment you
wish to connect, there are various ways you could
connect the recorder. Use only one of the
connections described below.
Please refer to the manuals of your TV, VCR,
Stereo System or other devices as necessary to
make the best connections.
Caution
– Make sure the recorder is connected directly to the
TV. Tune the TV to the correct video input channel.
– Do not connect the recorder's AUDIO OUTPUT jack
to the phono in jack (record deck) of your audio
system.
– Do not connect your recorder via your VCR. The
DVD image could be distorted by the copy
protection system.

RF coaxial connection

Connect the ANTENNA OUT jack on the Recorder to
the antenna in jack on the TV using the supplied 75-
ohm Coaxial Cable (R).
How to set the Recorder's RF output channel
1. When the Recorder is turned off, press and hold
PR/CH (V/v) for more than five seconds.
or [ch04] appears in the display window.
2. Press PR/CH (V/v) to change the RF output
channel (ch03 or ch04).
3. Tune the TV to this channel.
Video connection
Connect the VIDEO OUTPUT jack on the recorder to
the video in jack on the TV using the video cable (V).
Audio (Left/Right) Connection
Connect the left and right AUDIO OUTPUT jacks of
the recorder to the audio left and right INPUT jacks on
the TV using the audio cables (A1, A2). Do not
connect the recorder's AUDIO OUTPUT jack to the
phono in jack (record deck) of your audio system.
12

Component Video connection

Connect the COMPONENT OUTPUT jacks on the
recorder to the corresponding input jacks on the TV
using an Y P P
B R
If your television is a high-definition or "digital ready"
television, you may take advantage of the recorder's
progressive scan output for the highest video
resolution possible. If your TV does not accept the
Progressive Scan format, the picture will appear
scrambled if you try Progressive Scan on the recorder.
Set the Progressive Scan to [ON] on the setup
menu for progressive signal, see page 17.
Note:
Progressive scan does not work with the analog video
connections (yellow VIDEO OUTPUT jack).
Caution
Once the setting for Progressive Scan output is
entered, an image will only be visible on a
Progressive Scan compatible TV or monitor. If you set
Progressive Scan to [ON] in error, you must reset the
recorder. First, remove the disc in the recorder. Next,
press STOP (x) and hold it for five seconds before
releasing it. The video output will be restored to the
standard setting, and a picture will once again be
visible on a conventional analog TV or monitor.
[ch03]
Rear of Recorder
Rear of TV
cable (C).
Rear of TV
COMPONENT/PROGRESSIVE SCAN
AUDIO INPUT
VIDEO INPUT
L
Y R
Pr Pb
C A2
R V A1