Setting Parameters - ABB 2CSE1219EL Manual Del Usuario

USER INSTRUCTIONS
S E T T I N G PA R A M E T E R S
Press the SET/PROG key once to set the parameters.
The message "SET" is displayed on the VDU.
The symbol or starts to blink at the same time.
At this point the following can be modified in sequence:
- air conditioning/heating operating type
- the day of the week
- hours
- minutes
- temperature unit of measurement
- Set point T1
- Set point T2
- Set point T3
- antifreeze/high temperature protection temperature value
- self-learning activation (only available in "heating" operating mode)
- differential regulation value
The value of each parameter is confirmed by pressing the MODE key.
Exit from the setting phase is done by pressing the SET key again or, automatically, 30 sec-
onds after the last key entry.
30