SIOUX 4035 Serie Instrucciones De Seguridad página 3

OPERATING INSTRUCTIONS FOR 4035 SERIES IMPACT WRENCHS
AIR SUPPLY
The efficiency of the tool is dependent on the proper supply of clean dry air at 90 psig (6.2 bar). The use of a line filter, pressure regulator,
and lubricator will insure maximum output and life of tools. Before connecting tool, blow out the air line to remove water and dirt which may
have accumulated.
HOSE AND HOSE CONNECTIONS
Supply hose should be not less than 3/8" (10 mm) I.D. Extension hoses should be at least 1/2" (13 mm) I.D. Use couplings and fittings with
at least 1/2" (13 mm) I.D. When using quick couplers, install a 6 ft (2 m) leader hose between tool and quick couplers.
LUBRICATION
Use SIOUX No. 288 air motor oil. An airline lubricator, set to deliver 2 to 4 drops per minute, is recommended. If a lubricator is not used,
add .12 oz. (3.6 cc, 36 to 45 drops) of oil into the air inlet once daily.
The impact mechanism chamber is sealed at the factory and should not require any additional oil.
GENERAL OPERATION
Reversing Spindle Rotation
The direction of spindle rotation is controlled with the reversing lever located at the back of the tool.
For counterclockwise rotation.
Ensure that the socket is held square to the fastener and that the tool is in-line with the socket.
Output Control
The output control is located on the back of the wrench and regulates the power. It has five positions. "1" is the lowest power setting and
"5" is the highest.
Sockets
Use only impact sockets in good shape.
Use deep impact socket impact rather than extension bars.
IF THE TOOL LOOSES POWER, CHECK THE FOLLOWING:
• Air Pressure
Ensure that there is an adequate supply of clean, dry air at 90 psi (6.2 bars).
• Sockets
Check for loose, worn, or cracked sockets.
• Hose Size
Ensure that the hoses, couplers and fittings meet the criteria specified in "HOSE AND HOSE CONNECTIONS" above.
• Dirt or Debris In Tool or Muffler
Clean tool or muffler as needed.
We, Sioux Tools Inc., 250 Snap-on Drive, P.O. Box 1596, Murphy, NC, 28906, USA, declare under our sole responsibility that the products
to which this declaration relates are in conformity with the following standard or standards or other normative document or documents:
July 1, 2003
Murphy, North Carolina, USA
Date and place of issues
For clockwise rotation.
SOUND AND VIBRATION READINGS
Catalog No. *Sound Pressure dBA *Sound Power dBA *Vibration m/s
4035 92.3
4035B 92.3
4035C 92.3
*per PN8NTC1
DECLARATION OF CONFORMITY
4035, 4035B, 4035C
EN 792 (draft), EN 292 Parts 1&2, ISO 8662, Pneurop PN8NTC1
following the provisions of
89/392/EEC as amended by 91/368/EEC & 93/44/EC Directives.
Gerald E. Seebeck
Sioux Tools Inc.
Name and position of issuer
103.9
103.9
103.9
*per PN8NTC1 *per ISO 8662
President
3
2
5.8
5.8
5.8
Signature of issuer