Equipment Description; Installation; Location; Connection To The Mains - Selecta Electemp-TFT Manual De Instrucciones

INSTRUCTION MANUAL
PROGRAMACIÓN
AJUSTES
PROGRAMMING
SETTINGS
TRABAJO
TASK
Fig 8.1. Home screen
100ºC PROG 0 RAMP
95ºC
Step: 2 2ºC/m
Fig 6. Temperature profile
J
.P. SELECTA s.a.u.
CODE 80080 REV L

6. Equipment Description

This equipment is designed to control equipments with heating or compressor
and to adjust the heating or cooling power value by means of a temperature
probe. To do this, connect the power supply of the equipment to be controlled
in the rear base of the ELECTEMP - maximum admissible power 3100W (230V)
/ 1650W (110V). It will give some electrical pulses to reach the desired tem-
perature value. It is recommended that if the equipment to be controlled has
power adjustment, it should be placed in its maximum position. On the other
hand, place the temperature probe in contact with the control point. Make sure
the probe has good mechanical contact so that the reading is correct.

7. Installation

Unpack the equipment and visually check that the contents are in good con-
ditions. Keep the package for some days.

7.1 Location

Place the equipment on a flat level stable surface, suitable for the equipment
weight.
To work in a comfortable way, please leave a free space of 30cm around the
equipment and a minimum of 40cm at the rear part. Note that all connections
are made on the back of the computer.
7.2 Connection to the mains
Plug the equipment to a near socket suitable for the equipment power. Use the
connection cable supplied or a similar one.
For your safety, the equipment must be earthed.
Before plugging the machine, check that the voltage supply and the frequency
corresponds to the one indicated in the equipment characteristics plate.

8. Operation

All the equipment functions are set with the touch screen. Gently press with
your finger in the center of each icon.
When starting the computer, the home screen will be shown (Fig 8.1)
• SETTINGS:
-
-
control.
-
-
-
PROGRAMMING:
•
-
ratures, times and ramps up or down, if you work in cold mode.
• TASK:
Time 01:00
-
00:53
temperature profile.
INF
The possibility of giving a heat treatment following a "temperature profile"
allows to avoid cracks, breaks, changes of color, etc.
02:13
A temperature profile is a succession of "ramps" and "dells".
A ramp is specified by a slope (always positive in heat) of °C/minute.
A dell is specified by a temperature and a time.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
MAY 2019 (It can be modified without notice)
Time and date: menu to set the date and time.
PID and Autotuning: menu to set the parameters of temperature
Downloading recorded data.
Temperature correction.
Temperature alarm limits.
Allows you to program the temperature profile, by defining tempe-
Allows you to select and launch the operating temperature or a
Page: 16
Tel 34 937 700 877 Fax 34 937 702 362