Selecta Electemp-TFT Manual De Instrucciones página 20

INSTRUCTION MANUAL
PORT
RS232
INTERVAL
No save
MODE
Start
USB
Fig 8.2.3 Communication
J
.P. SELECTA s.a.u.
CODE 80080 REV L
• Temperature probe type:
pT100:
K:
Note: Connect only one type of probe. It can give erroneous values.
When changing the probe, turn off/on the device to ensure a correct reading.
Working mode: heat/cold
HEAT: indicates to the equipment that the system regulates equipments which
generate heat.
COLD: indicates to the equipment that the system regulates equipments which
generate cold.
8.2.3 Communication and logs type
The equipment can store readings from time to time and send them to a com-
puter or store them in the internal memory and then download them to a USB
memory stick.
«PORT»
• RS232:
• USB:
«INTERVAL»
«MODE»
• Start:
• Set point:
• PC:
«USB»
Note: the equipment only saves the last process. When you start a new process,
the stored data will be deleted from memory.
If you have the USB mode activated, simply connecting the USB memory at the
end of a process will be enough to download the data file. Follow the instructions
that appear on the screen.
The generated file is a text file that can be opened with any text editor or
spreadsheet.
Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
MAY 2019 (It can be modified without notice)
from -150.0ºC to 250ºC
from 10ºC to 1300ºC
Set the readings storing mode:
Send the temperature readings to a computer by a serial
cable (DB9 type).
Store the readings.
Select with
data sending.
Select the data to be stored:
Save all temperature readings.
Save temperature readings, since the set point temperature
has been reached.
Send data, it is not stored.
Update the equipment internal firmware through a file that
can be requested from JP Selecta, s.a.u.
Page: 20
the register time interval and the
Tel 34 937 700 877 Fax 34 937 702 362