Vollrath FC-6IH-01120 Instrucciones De Instalación

SAFETY PRECAUTIONS
To ensure safe operation, read the following statements and understand
their meaning. This manual contains safety precautions which are
explained below. Please read carefully.
WARNING
Warning is used to indicate the presence of a hazard that will or can
cause severe personal injury or death.
CAUTION
Caution is used to indicate the presence of a hazard that will or can
cause minor or major personal injury if the caution is ignored.
NOTICE: Notice is used to note information that is important but not
hazard-related.
BEFORE YOU BEGIN
1. Download the specification sheet for your drop-in from
Vollrath.com. You will need to refer to this document for dimensions
and power requirements.
2. Verify the proper electrical outlet is available at the installation site.
NOTICE: This equipment requires a dedicated electrical circuit.
NOTICE: Do NOT modify the cord or plug on the drop-in. Modifying
any component may damage the drop-in or cause injury,
and will void the warranty. See the specification sheet on
Vollrath.com for electrical specifications.
3. Know the countertop manufacturer's requirements for preparing and
installing equipment into the countertop prior to starting installation.
CLEARANCE AND ENVIRONMENT REQUIREMENTS
• Drop-in requires: 2 (5.1 cm) of clear space on the long and short
"
sides, and 6 (15.2 cm) below, measured from the bottom of the
"
rating plate.
• Requires unrestricted intake and exhaust air ventilation for proper
operation of the controls. The maximum intake temperature must
not exceed 110°F (43.3°C). Temperatures are measured in ambi-
ent air while all appliances are in operation.
• Indoor use only. Room temperature and HVAC can effect perfor-
mance temperatures.
Modular Induction Dry Well Drop-ins
Item No.
FC-6IH-01120 One Well, 120V
FC-6IH-01208 One Well, 208-240V
FC-6IH-02120 Two Well, 120V
FC-6IH-02208 Two Well, 208-240V
1. RECORD THE SERIAL NUMBER
Please record the drop-in serial number in the space provided in the
Operator's Manual. The serial number is located on the rating plate on
the drop-in. See below.
2. PREPARE THE COUNTERTOP AND CABINET
NOTICE: Refer to the drop-in specification sheet for cutout
NOTICE: Countertop materials require specific preparation. Refer to
1. Cut the required openings in the countertop and cabinet.
2. Clean any debris from the cut out area(s).
3. Reinforce the countertop support as needed per the countertop
manufacturer guidelines and the weight of the equipment.
3. MOUNT THE DROP-IN
NOTICE: Do not block the air intakes. They are required for proper
1. Install the gasket into the drop-in flange.
2. Center the drop-in into the cutout opening.
3. Hand-tighten the thumbscrews of the mounting clips in an
alternating pattern to evenly compress the gasket. The gasket should
compress evenly between the well and mounting surface.
4. Apply silicone sealant around the perimeter of the drop-in.
©
2018 The Vollrath Company L.L.C. Part No. 351361-1 ml
Installation Instructions
Description Item No.
FC-6IH-03120 Three Well, 120V
FC-6IH-03208 Three Well, 208-240V
FC-6IH-04208 Four Well, 208-240V
FC-6IH-05208 Five Well, 208-240V
FC-6IH-06208 Six Well, 208-240V
dimensions, air flow and venting requirements, minimum
clearance distances and environment requirements.
the countertop manufacturer for instructions regarding
proper installation of equipment into the material.
ventilation of electrical components. Air intakes may be
located on multiple sides the drop-in.
Description
Rating Plate
Air intake
3/27/18