Publicidad
Idiomas disponibles
Idiomas disponibles
G eneral information
The operator should not neglect to carefully
read the following instructions and those of
the mainframe HM8001, to avoid any
operating errors and to be fully acquainted
with the module when later in use. After
unpacking the module, check for any
mechanical damage or loose parts inside.
Should there be any transportation damage,
inform the supplier immediately and do not
put the module into operation.
This plug-in module is primarily intented
for use in conjunction with the Mainframe
HM8001. When incorporating it into other
systems, the module should only be operated
with the specified supply voltages.
Safety
This instrument has been designed and
tested in accordance with IEC Publication
1010-1, Safety requirements for electrical
equipment for measurement, control, and
laboratory use. It corresponds as well to the
the CENELEC regulations EN 61010-1. All
case and chassis parts are connected to the
safety earth conductor. Corresponding to
Safety Class 1 regulations (three-conductor
AC power cable). Without an isolating
transformer, the instruments power cable
must be plugged into an approved three-
contact electrical outlet, which meets Inter-
national Electrotechnical Commission (IEC)
safety standards.
Warning!
Any interruption of the protective
conductor inside or outside the instrument
or disconnection of the protective earth
terminal is likely to make the instrument
dangerous. Intentional interruption is
prohibited.
The istrument must be disconnected and
secured against unintentional operation if
there is any suggestion that safe operation is
not possible. This may occur:
•
if the instrument has visible damage,
•
if the instrument has loose parts.
•
if the instrument does not function,
•
after long storage under unfavourable
circumstances (e.g. outdoors or in moist
environments),
•
after excessive transportation stress (e.g.
in poor packaging).
14
When removing or replacing the metal case,
the instrument must be completely
disconnected from the mains supply. If any
measurement or calibration procedures are
unavoidable on the opened-up instrument,
these must only be carried out by qualified
personnel acquainted with the danger involved.
Symbols as Marked on Equipment
ATTENTION refer to manual.
DANGER High voltage.
Protective ground (earth) terminal.
Operating conditions
The ambient temperature range during
operation should be between +10°C and
+40°C and should not exceed -40°C or +70°C
during transport or storage. The operational
position is optional, however, the ventilation
holes on the HM8001 and on the plug-in
modules must not be obstructed.
Warranty
Before being shipped, each plug-in module
must pass a 24 hour quality control test.
Provided the instrument has not under-
gone any modifications Hameg warrants that
all products of its own manufacture conform
to Hameg specifications and are free from
defects in material and workmanship when
used under normal operating conditions and
with the service conditions for wich they were
furnished. The obligation of HAMEG here-
under shall expire two (2) years after delivery
and is limited to repairing, or at its option,
replacing without charge, any such product
which in Hamegs sole opinion proves to be
defective with the scope of this warranty. This
is Hamegs sole warranty with respect to the
products delivered hereunder. No statement,
representation, agreement or understanding,
oral or written, made by an agent, distributor,
representative or employee of, which is not
contained in thiss warranty will be binding
upon Hameg, unless made in writing and
executed by an authorized Hameg employee.
Hameg makes no other warranty of any kind
whatsoever, expressed or implied, and all
implied warranties of merchantibility and
fitness for a particular use which exceed the
aforestated obligation are hereby disclaimed
Änderungen vorbehalten / Subject to change without notice
Publicidad
