Hoover Cyclonic Upright El Manual Del Propietario página 6

2-4
Cord rewind
Grasp the end of the plug and pull
to release cord from cord reel. After
desired cord length is reached, the
cord will lock into position.
To return cord for storage, hold plug
and press on button (A) at top of
cord reel. To prevent cord from
whipping, hold plug until cord is
rewound.
2-7
Carrying cleaner
The cleaner can also be moved by
using the carrying handle.
2-10
Settings
For maximum cleaning perfor-
mance, the following carpet height
settings are recommended:
• Lowest setting: for all types of
carpet.
Note: If the cleaner is difficult to
6
2-5
A
Telescoping handle
The telescoping handle includes
adjustable settings to various
heights for user comfort. The handle
is designed to retract into the body
of the cleaner for convenience in
storing or carrying the cleaner.
Lower the handle by depressing the
button (B) located at the handle
base and pushing the handle down.
Raise the handle by depressing the
button and pulling the handle
upward, locking it into the desired
position.
2-8
Handle positions
The handle of your cleaner has
three positions; upright for storage
and when using cleaning tools;
operating position for general
operation on carpet and floors; low
for reaching under low furniture.
Step on handle release lever to
lower handle.
push, turn knob to the next higher
setting.
• Higher settings: for very deep
pile carpet, where easier pushing
effort is desired, while maintaining
good cleaning performance.
2-6
B
Transporting cleaner
To move your cleaner from room to
room, put handle in upright position,
tilt cleaner back on rear wheels and
push forward.
2-9
C
Carpet height
adjustment
The cleaning of carpet and rugs
takes place at the nozzle (C).
When it is necessary to raise and
lower the nozzle for various carpet
pile heights, turn the nozzle control
knob (D) to the desired setting.
D