Power Supply - ESTEBAN CMP-153 Instrucciones De Uso

REPAIR
If the product is not working properly, check the following points:
Problems / Symptoms
No mist when the
appliance is switched on
Mist stops while the
diffuser is in operation
Insufficient mist
s no
The light does not
switch on
or it
use
Should the problems persist please contact your retailer.
with
The manufacturer is not responsible for damages caused by improper use of the diffuser.

Power supply

Mains
Power
ng
Causes
The appliance is not plugged in
Water level too low
Water level exceeds 110 ml
The end of part A is obstructed
Water level too low
Accumulation of water drops in the part A
The ceramic disk is dirty
An excess of Estéban refresher oils or
essential oils has been poured into the
container
Accumulation of water drops in the part A
Diffuser failure
USB3 / 5V – 800mA
Compatible with USB mains adapter. Output: 5V
4 W
Solutions
Ensure that the USB lead is correctly connected to the device
and the USB port
Fill the water container
Empty out excess water
Make sure that nothing is preventing the release of the mist
Fill the water container
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Clean the ceramic disk as described in the « PRECAUTION
FOR USE » instructions
Empty the appliance and clean it
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Bring the diffuser back to the retailer within the after-sales
service support legal deadline
1A
9