Power Supply - ESTEBAN PARIS CMP-187 Instrucciones De Uso

REPAIR
GB
If the product is not working properly, check the following points:
Problems / Symptoms
The diffuser does not
start up or switches off
during diffusion
The indicator of the
diffuser flashes twice.
No mist when the
appliance is switched on
Mist stops while the
diffuser is in operation
aging
Insufficient mist
nated
might
The light does not
switch on
only)
Should the problems persist please contact your retailer.
The manufacturer is not responsible for damages caused by improper use of the diffuser.
ce

Power supply

Power
Causes
The battery has run out or does not have
enough charge
Water level too low
Water level too low
Water level exceeds 80 ml
The end of part A is obstructed
Water level too low
Accumulation of water drops in the part A
The ceramic disk is dirty
An excess of Estéban refresher oils has been
poured into the container
Accumulation of water drops in the part A
The diffuser is used in charge
Diffuser failure
USB 3 / 5V - min 1A / max 2A
This device is NOT compatible with USB PD / SCP / SoC fast chargers
7 W
Solutions
Connect the USB power cable to the back of the device
making sure not to tilt the diffuser if there is any
water remaining and plug it into a USB 3 port. Wait for the
battery to be completely recharged (the indicator will remain
illuminated without flashing).
Fill the water container
Fill the water container
Empty out excess water
Make sure that nothing is preventing the release of the mist
Fill the water container
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Clean the ceramic disk as described in the «PRECAUTION
FOR USE» instructions
Empty the appliance and clean it
Switch off the diffuser, remove part A then clean off the
accumulated water drops
Wait until the battery of the device is fully charged and use in
wireless mode
Bring the diffuser back to the retailer within the after-sales
service support legal deadline
GB
9