Tyco Electronics RECORDsplice RPI-SA100 Instrucciones De Instalación página 4

3.2 Splice
1
3 4
2
1 Dust cap
2 Spring
3 Body
4 Batch number
Assembly
1 Fixation points. Attaches the mounting
plate to the RCAT 100 for mounting on a
network element or a tripod.
2 Program controller. Activates the
processes inside the tool when the knob
is turned.
3 Dust cap cutting plate. Facilitates
dust cap removal.
4 Splice holder. Holds splice during
assembly.
5 Splice holder cover. Locks the splice
into the splice holder and shows the
correct splice position.
6 Splice holder lever. Opens the splice
holder cover and lifts the splice when
activated.
7 Fiber holder. Ensures correct fiber
alignment and insertion during cleaving
and assembly.
4 Ordering info
Description Unit of measure
RPI-SA100
RPI-TK100
RPI-SA100 = splice. 1 pack = 10 splices
RPI-TK100 = toolkit
1
Min.order qty.
pc 1000
pc 1
8 Strip length indicator. Facilitates the
verification of the min./max. stripping
length of the fiber.
9 Front fiber clamp. Clamps and aligns
the fiber.
10 Fiber clamp lever. Activates the front
and the back fiber clamp.
11 Fiber entrance hole. Entrance of the
fiber towards the cleaver (fiber funnel).
12 Back fiber clamp. Clamps the fiber to
guarantee some spare fiber length during
fiber assembly.
13 Cleave control window. Informs the
installer of a fiber break fault during the
cleaving process.
14 Cleave length indicator. Facilitates
the verification of the length of the fiber
after cleaving.
15 Cleave counter window. Informs the
installer of the number of cleaves that
still can be made.
16 Fiber cut-off storage. Sealed storage
basket for the cut-off fiber.
(Can not be opened!)
17 RCAT handle. To carry and protect
RCAT.
18 RCAT strap holder. Fixation points to
carry RCAT with strap.
19 Splice holder end stop.
Group box
10 packs
4
Shipping box
100 packs