Wifi Setup; Before Setting Up - XYZ Printing Da Vinci nano w Guía Rápida

WiFi Setup

Before setting up

1. The network printing function is only available when the printer and the computer are both connected to
the same wireless network.
2. Before connecting the printer, your wireless network settings need to be adjusted. For more information,
refer to the instruction manual of your wireless router.
3. The wireless network's channel width needs to be set to 20 MHz for the printer to connect to it wirelessly.
Refer to the vendor instruction manual for more information.
4. The nano w supports WEP, WPA, and WPA2 security encryption standards. Wireless pass word information
will be requested when setting up the printer connection.
Setting up WiFi
Connect the printer to your
01
computer with the USB cable,
open "XYZprint" and turn on the
printer.
In the [WiFi setting] window,
04
please follow the onscreen
instruction to key in the related
information to complete wireless
connecting setup.
Note:
• Name the printer and wireless network with the alphanumeric characters only.
• If no connection is detected within 90 seconds, the printer will time-out. If this is the case, check that the configuration process is
correct and try again.
• Confirm your wireless network's security key on the router's wireless settings page.
• The recommended wireless connection distance between your printer and the wireless networking device needs to be within 10
meters. The connection quality, will depend on the power of your networking device, and the environment you are connecting
the two devices in. For more information, please refer to your networking device's instruction manual.
Select the connected 3D Printer
02
on Dashboard page.
Once the connection method has
05
been changed from USB to WiFi,
you can unplug the USB cable
and continue with the printing
process.
a
b
Select the [SetUp] > [Wireless]
03
to open the WiFi connection
settings.
If you need to stop or change
06
the wireless setting, please click
[Connect to new network /
Disconnect].
10