Publicidad
Warranty: Refer to standard Hilti terms and conditions of sale for warranty information.
Failure to observe these installation instructions, use of non-Hilti anchors, poor or questionable concrete conditions,
or unique applications may affect the reliability or performance of the fastenings.
Product Information
– Always keep this instruction for use together with the product.
– Ensure that the instruction for use is with the product when it is given to other persons.
– Safety Data Sheet: Review the DS before use.
– Check expiration date: See expiration date imprint on foilpack manifold (month/year). Do not use expired product.
– Foil pack temperature during usage: +5 °C to 40 °C / 41 °F to 104 °F.
– Conditions for transport and storage: Keep in a cool, dry and dark place between +5 °C to 25 °C /
41 °F to 77 °F.
– For any application not covered by this document / beyond values specified, please contact Hilti.
– Partly used foil packs must be used up within 4 weeks. Leave the mixer attached on the foil pack manifold and store
under the recommended storage conditions. If reused, attach a new mixer and discard the initial quantity of anchor
adhesive.
WARNING
Improper handling may cause mortar splashes. Eye contact with mortar may cause irreversible eye damage!
– Always wear tightly sealed safety glasses, gloves and protective clothes before handling the mortar!
– Never start dispensing without a mixer properly screwed on.
– When using an extension hose: Discard of initial mortar flow must be done through supplied mixer only (not through
the extension hose).
– Attach a new mixer prior to dispensing a new foil pack (snug fit).
– Caution! Never remove the mixer while the foil pack system is under pressure. Press the release button of the
dispenser to avoid mortar splashing.
– Use only the type of mixer supplied with the adhesive. Do not modify the mixer in any way.
– Never use damaged foil packs and/or damaged or unclean foil pack holders.
Poor load values / potential failure of fastening points due to inadequate borehole cleaning. The boreholes must be dry
and free of debris, dust, water, ice, oil, grease and other contaminants prior to adhesive injection.
– For blowing out the borehole - blow out with oil free air until return air stream is free of noticeable dust.
– For flushing the borehole - flush with water line pressure until water runs clear.
– Important! Remove all water from the borehole and blow out with oil free compressed air until borehole is completely
dried before mortar injection (not applicable to hammer drilled hole in underwater application).
Ensure that boreholes are filled from the back of the boreholes without forming air voids.
– If necessary, use the accessories / extensions to reach the back of the borehole.
– For overhead applications use the overhead accessories HIT-SZ / IP and take special care when inserting the faste-
ning element. Excess adhesive may be forced out of the borehole. Make sure that no mortar drips onto the installer.
– If a new mixer is installed onto a previously-opened foil pack, the first trigger pulls must be discarded.
– A new mixer must be used for each new foil pack.
Printed: 26.01.2016 | Doc-Nr: PUB / 5251867 / 000 / 02
Hilti HIT-RE 500 V3
43
en
es
fr
Publicidad
