Installation - Klarstein 1003013 Serie Manual Del Usuario

Selecting location
When selecting a position for your unit you should make sure the floor is flat and firm, and the room is well
ventilated. Avoid locating your unit near a heat source, e.g. cooker, boiler or radiator. Also avoid direct sunlight
as it may increase the electrical consumption. Extreme cold ambient temperatures may also cause the unit
not to perform properly. This unit is not designed for use in a garage or outdoor installation. Do not drape the
unit with any covering.
When installing the unit, ensure that 10 cm of free space is left at both sides, 10 cm at the rear and 30 cm
at the top of the unit. This will allow cold air to circulate around the wine cooler and improve the efficiency
of the cooling process.
Reversing the Door Swing
1. Remove the screws of the upper hinged cover
and that top hinged cover on one side
2. Then, remove the middle hinge, lower hinge and
door. After that, remove the upper, middle and
lower hinges on the other side.
3. Install the lower hinges. Then put on the middle
hinge after the door is put in place. After that,
install the refrigerator door and then put on the
upper hinge and cover.

Installation

upper hinge
middle hinge
lower hinge
18