Publicidad
Step 14
Carefully stand your unit upright.
å
Separate the EXTENSION SLIDES (Z) from the EXTENSION RAILS (Y) as shown in the upper diagram below. Be prepared,
å
the parts are greasy.
Fasten the EXTENSION RAILS (Y) to the DRAWER UPRIGHTS (E) and UPPER UPRIGHT (D). Use eight GOLD 5/16" FLAT
å
HEAD SCREWS (3S) through holes #1 and #3.
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner
å
cartridge of the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the UPRIGHTS. Turn a SCREW into
this hole.
Page 18
Z
Push the release lever in and pull the SLIDE from the RAIL.
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
E
4
3
3S
4
4
3
D
4
3
2
Y
2
1
Y
1
Open end
416879
Y
E
3
Y
2
2
Y
1
1
Open end
www.sauder.com/services
Publicidad
