Publicidad
Step 19
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (X) to the DOOR EXTENSION BLOCK (W)
å
as shown in the lower diagram. Use the screws in the HINGES.
You should start each SCREW a few turns before completely
tightening any of them.
Fasten a KNOB (60K) to the DOOR (X). Use a BLACK 1-1/8"
å
PAN HEAD SCREW (9S).
See the next step for DOOR adjustments.
å
www.sauder.com/services
Stop
Mounting
screw
BLACK 1-1/8" PAN HEAD SCREW
416879
Hinge
W
60K
X
9S
(1 used in this step)
Page 23
Publicidad
