Hilti DX450 Manual De Instrucciones página 16

Operation
1
Hold tool with muzzle upwards. Insert fasten-
er point first in cocking lever and let it slide
down.
5
Check power regulation.
Indicator in rear position means max. power.
Select a cartridge power level and power set-
ting to suit the application.
If you cannot estimate this on the basis of
previous experience, always begin with the
lowest power. Select a cartridge of the lowest
power level (color code) and turn the power
regulating wheel to 1.
16
Printed: 24.03.2014 | Doc-Nr: PUB / 5069832 / 000 / 03
2
Pull firmly to release and swing over cocking
lever till aligned with muzzle.
6
Caution!
Never use the palm of the hand to push
back the fastener guide and never attempt
to pull it back by way of the nail / washer.
This could present a risk of injury to the
operator!
3
Pull back loading grip on cocking lever as far
as it goes. This positions fastener correctly in
guide. Return grip and pivet cocking lever
back to original position.
7
Hold the tool at right angles to the material in
which the fastener is to be driven, press the
muzzle against the surface and pull the trig-
ger.
4
Insert cartridge magazine in base of grip.
Caution!
Do not insert magazine until fastener has
been loaded.
If this sequence is not observed the first car-
tridge will be missed (not fired).