Special Instructions - Target ES 1409 Instrucciones De Operación Y Lista De Piezas

This symbol indicates that the machine
is in conformance with the applicable
European directive.

SPECIAL INSTRUCTIONS

The disc cutter is designed to provide safe and
reliable service
corresponding with the instructions, but it can
present dangers for the user and risks of damage,
consequently regular on site inspection is
necessary to ensure :
• Perfect technical condition (use for the purpose
for which it is intended and taking into account
any risks, and correction of any malfunction
detrimental to safety).
• Use a diamond disk for cutting with water
(sawing new or old concrete, tarmac or
asphalt). No other type of disk is allowed
(abrasive, saw, etc . . .).
• Competent staff (qualifications, age, training)
who have read and understood the manual in
detail before starting work : any electrical,
mechanical or other problem should be
investigated by a qualified maintenance
engineer (electrician, maintenance manager,
approved dealer, etc . . .).
• That the warnings and instructions marked on
the machine are followed (adequate personal
protection, correct use, general safety
instructions, etc).
• That no modification, transformation or addition
is detrimental to safety and that it is carried out
without prior
manufacturer.
• Respect of the maintenance intervals and
periodical checks recommended.
• That only genuine spare parts are used for
repairs.
FAILURE TO COMPLY WITH THESE
WARNINGS COULD RESULT IN
DEATH OR SERIOUS BODILY INJURY.
2
in operating conditions
authorization from
DO carefully read and understand all the
instructions before operating the saw.
DO always keep all guards in place.
DO aways wear safety approved hearing, eye,
head and respiratory protection.
DO keep all parts of your body away from the
blade and all other moving parts.
DO know how to stop the saw quickly in case of
an emergency.
DO shut off the engine and allow it to cool before
refueling.
DO inspect the blade, flanges and shafts for
damage before installing the blade.
DO use only blades marked with a maximum
operating speed greater than the blade shaft
speed.
DO use caution and follow the instructions when
loading and unloading the saw.
DO NOT allow other persons to be near the saw
when starting, refueling or when cutting.
DO NOT operate gasoline engines in an enclosed
area unless it is properly vented.
DO NOT use damaged equipment or blades.
the
DO NOT operate the saw in areas of combustible
material. Sparks from the saw could
cause a fire or an explosion.
DO NOT allow blade exposure from the guard to
be over 180 degrees.
DO NOT leave the saw unattended with the motor
running.
DO NOT operate the saw while under the
influence of drugs or alcohol.
DO
DO NOT