Genie GER-R Guia De Instalacion

EMERGENCY RELEASE KIT
MODEL GER-R
WARNING: To prevent serious injury or death
!
Disconnect power to garage door opener before performing this installation
Operation Information
The Emergency Release Kit is designed to provide access to your garage from the outside in the
event of an electrical power failure and no other means of entry is available.
The Emergency Release Kit is designed for use with standard-type garage doors and garage door
openers. If any modifications were required to your garage door(s) or garage door opener(s) at
the time of installation, the length of cable supplied may not be adequate and additional cable
will have to be purchased locally.
Genie Brand production model openers are shown for illustration purposes and may not depict your type
of opener connection point. Inspect your particular model and brand of opener before performing this
installation to ensure that this product will safely operate your release system.
Determine Door Type:
SECTIONAL DOORS
The lock assembly is generally installed in the top door section directly beneath the door opener
carriage release mechanism.
ONE-PIECE DOORS
The lock assembly must be installed approximately midway between the top and bottom of the
garage door and directly beneath the door opener carriage release mechanism.
INSTALLATION:
1. Drill a 3/16" pilot hole through the garage door where you plan to position the center of the
lock assembly.
2. At this pilot hole, drill a 3/4" hole about half way through the door–follow this by drilling a
3/4" hole from the inside of the door to finish the hole completely through the door. (This
procedure eliminates any chipping on wooden doors.)
3. Insert the lock assembly and use it as a template for determining the location of the
mounting bolt holes.
4. Drill 3/16" holes through the door at these two points.
5. Insert bolts and apply flat washers and nuts and tighten securely.
6. Feed cable and hook through the uppermost hole in the door arm. (Belt & Chain Channel
models only)
7. Feed "S" hook into hole in carriage release that the Emergency Release Cord is attached.
8. Crimp "S" hook with pliers to secure. Do not crush plastic release handle.
* Tube rail models require a modification to the carriage release mechanism.
See owners manual for required changes.
USE:
1. Insert the key, turn it 1/2 turn and remove the entire inside lock assembly. This allows access
to the cable, which is connected to the carriage release device on your door opener.
2. Pull out on cable/cylinder to disengage the carriage release allowing manual operation of
the garage door.
3. Replace the cable and lock assembly after disconnecting the carriage by inserting it into the
housing and turning the key 1/2 turn to the locked position and remove key.
4. Manually open the door.
5. Reconnect the door opener carriage release device as per manufacturer's instructions.
© 2016 GMI Holdings INC.
1-2
3/16
3/4
3-5
Outside Door
Porte Extérieur
Puerta Externa
3/16
07/2016
6-8
*
6-8
9-10
Chain & Belt Type Release
Déclenchement de type
chaîne et courroie
Liberación del Tipo de
Cadena y Correa
Chain & Screw Type Release
Déclenchement de type
chaîne et vis
Liberación del Tipo de Cadena
y Tornillo
37392503111