Heatworks 1 Manual página 18

a. The water heater or any of its component parts
have been subject to misuse, alteration, neglect,
impact, or accident; or
b. The water heater has not been installed in
accordance with the applicable local plumbing and/or
building code(s) and/or regulation(s); or
c. The water heater has not been installed or
maintained in accordance with Manufacturer's
instructions, or has been installed with improper
orientation, improper fastening, improper use of pipe
dope/plumbers putty or with the use of any sealant;
or
d. The water heater has sediment inside the unit; or
e. The water heater experiences any water pressure or
flow interruptions (ie: normal inlet water pressure is
outside of the published specification for the heater),
is exposed to any condition that causes the heater to
turn on before the air is purged from the heater; or
f. The water heater has been exposed to conditions
resulting from floods, earthquakes, winds, fire,
freezing, lightning, or circumstances beyond the
Manufacturer's control; or
g. The water heater's outer wrapper/sticker has been
broken or tampered with; or
h. The water heater has been used for other than the
intended purpose (ie: use with liquids other than
potable water); or
i. The water heater has been tampered with, either
electronics or software; or
CAUTION: Breaker must remain off until installation is complete.
16
j. If there is any disassembling of any components
other than the wire connectors and end plates; or
k. The water heater is subjected to applications of DC
voltage; or
l. The water heater is operated without inlet filter
screen located inside the water inlet; or
m. The water heater installation exposes the unit to
the elements; or
n. The workmanship of any installer; or
o. The spray head is not regularly descaled.
3) Owner, and not Manufacturer or its
agent/representative, is liable for and shall pay for all
field charges for labor or other expenses incurred in the
removal or any NON-COVERED WARRANTY expense
incurred by Owner.
LIMITED WARRANTY VOIDED IF:
1) The unit is tampered with or self-serviced in anyway.
2) The unit is installed outdoors, without adequate
protection from the elements.
3) The unit is installed in an orientation other than
specified in the Installation and User Manual.
4) The unit is used with any liquids other than potable
water.
5) More than 10% glycol is used with a radiant heating
application.
6) The unit is used with any unapproved chemicals.
Please contact Manufacturer before using any chemicals
in your MODEL 1 so not to void your warranty.
www.myheatworks.com