Installing The Mounting Brackets; Important - Heatworks 1 Manual

4

INSTALLING THE MOUNTING BRACKETS

IMPORTANT: The Heatworks MODEL 1 must be oriented
horizontally.
The cold water inlet must be on the bottom of the
MODEL 1, and the outlet must be on the top. (Shown in
Heatworks MODEL 1 Diagram; page 3)
Do not use any other mounting method than the
brackets and zip ties provided.
STEPS
1) Position (2) mounting brackets approximately 6 inches
apart and level to support the weight of the MODEL 1,
which is approximately 15 pounds when full of water.
HEATWORKS RECOMMENDS:
strongly recommended for installation, or drill directly
into studs. Do not attach to drywall without drywall
anchors.
2) Secure mounting brackets to a flat surface, such as a
wall, using mounting (4) bracket screws.
3) Place the MODEL 1 on the brackets. Check the position
and orientation to ensure the unit is level, with the inlet
on the bottom and the outlet on the top.
4) Thread (2) cable ties through the brackets, around the
MODEL 1.
CAUTION: Breaker must remain off until installation is complete.
4
Dry wall anchors are
YOU ARE NOW READY TO PROCEED TO PLUMBING
INSTALLATION
Please continue to page 5
www.myheatworks.com