Adjusting The Temperature - Heatworks 1 Manual

ADJUSTING THE TEMPERATURE

After the MODEL 1 has been properly installed and is
receiving power, the digital display will show the current
water temperature setting. The average shower
temperature is between 104 ° and 110 ° F (40 ° and 43 ° C).
SWITCHING BETWEEN FAHRENHEIT AND CELSIUS
STEPS
1) Press the top button to increase the temperature
setting. Press the bottom button to decrease the
temperature setting.
CAUTION: Breaker must remain off until installation is complete.
10
Outlet / Top
Inlet / Bottom
2) Select temperature between 50 °F (4 °C) and 120 °F
(49 °C).
3) Verify your desired temperature appears on the digital
display.
HEATWORKS RECOMMENDS: Because newer model
dish washers are typically equipped with an internal
heating element, and most laundry detergents are
intended for use in cold or warm water, there is no
longer a need to set your water heater to a temperature
above 120 °F.
STEPS
1) Press both buttons at the same time and release the
bottom button for °C.
2) Press both buttons at the same time and release the
top button for °F.
CONGRATULATIONS!
YOU HAVE COMPLETED THE INSTALLATION OF THE
HEATWORKS MODEL 1.
www.myheatworks.com