Installing The Appliance And Charging The Rechargeable Battery; Assembly Of The Appliance - SEVERIN 7159 Manual De Instrucciones

Installing the appliance and charging the rechargeable battery

Assembly of the appliance

3 Installing the appliance and charging the rechargeable battery
illustrated Quick Start Guide
Installing the wall mount
Charging the rechargeable battery
It is best to charge the rechargeable battery before each use, especially after the appliance has not
been used for a while.
This increases the service life of the rechargeable battery and ensures the longest possible cleaning
cycles.
1. Plug the included mains adapter into the connection socket of the appliance.
2. Connect the included mains adapter to an outlet.
- The LEDs on the handle start to flash. The more the LEDs flash, the more advanced the charg-
ing process is.
- The LEDs go out once the rechargeable battery is fully charged. The charging process takes
around 3 hours when the rechargeable battery is empty.
3. Disconnect the mains adapter from the socket.
4. Disconnect the mains adapter's connector from the connection socket on the appliance.
TIP: The operation time with a fully charged rechargeable battery is approximately 20 min-
utes (in Power mode) or 30 minutes (in Eco mode).
For further information, see also illustrated Quick Start Guide.
18
1. Hold the wall mount to the wall, aligned in a vertical po-
sition.
2. Mark the holes with a pencil.
3. Drill the holes (approximately 8 mm Ø).
4. Insert the supplied dowels into the holes.
5. Fasten the wall mount using the screws supplied.