Publicidad
Step 12
Carefully turn your unit over onto its front edges. Unfold the BACK (G) and lay it over your unit.
å
Make equal margins along the two long edges and along the two short edges of the BACK (G). Push on opposite corners
å
of your unit if needed to make it "square".
Fasten the BACK (G) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the SHELF and UPRIGHTS.
å
Fasten the ADJUSTABLE FOOT (34E) to the BOTTOM (E). Use eight BLACK 9/16" LARGE HEAD SCREWS (1S).
å
NOTE: Adjustments to the ADJUSTABLE FEET will be made in Step 13 once your unit is standing upright.
å
These holes must line up over
the SHELF and UPRIGHTS.
34E
Page 16
E
BLACK 9/16" LARGE HEAD SCREW
(8 used for the FEET)
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
G
1S
418344
1N
NAIL
(64 used in this step)
www.sauder.com/services
Publicidad
